Dell S6000 - Upgrade Boot

A Enter the keywordA to upgrade the bootflash partition A
B Enter the keyword B to upgrade the bootflash partition B.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
9.0(0.0)
Added support for IPv6 for the file-url parameter.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000. Added support for the SSD on the
Z9000 only.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
You must reload FTOS after executing this command. Use the command upgrade
system stack-unit to copy FTOS from the management unit to one or more stack
members.
Example
Dell#upgrade system ?
flash: Copy from flash file system (flash://filepath)
ftp: Copy from remote file system, IPv4 or IPv6, (ftp://
userid:password@hostip/filepath)
scp: Copy from remote file system, IPv4 or IPv6, (scp://
userid:password@hostip/filepath)
stack-unit Sync image to the stack-unit
tftp: Copy from remote file system, IPv4 or IPv6, (tftp://
hostip/filepath)
usbflash: Copy from usbflash file system (usbflash://filepath)
Dell#
upgrade boot
Upgrade the bootflash image or bootselector image.
S6000
Syntax
upgrade boot {all | bootflash—image | bootselector-image}stack-
unit {0-5 | all}{booted | flash: | ftp: | scp: | tftp: |
usbflash:} {A: |B:}
76
File Management