Defaults The IP address assigned to the management interface is the default.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
To enable this snmp-server trap-source command, configure an IP address
on the interface and enable the interface configured as an SNMP trap source.
Related
Commands
snmp-server community — sets the community string.
snmp-server user
Configure a new user to an SNMP group.
S6000
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-
name udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5
| sha} auth-password] [priv des56 priv password] [access
access-list-name | ipv6 access-list-name | access-list-name
ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name
{group_name remote ip-address vrf vrf-name udp-port port-
number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-
password] [priv des56 priv password] [access access-list-name |
ipv6 access-list-name | access-list-name ipv6 access-list-name]
command.
Simple Network Management Protocol (SNMP) and Syslog
1351
To Next Page
Loading...
