0 7 QSFP 40GBASE-CR4-1M
APF11200012UR1 Yes
0 8 QSFP 40GBASE-CR4-1M
APF12300017GEY Yes
0 9 QSFP 40GBASE-CR4-1M
APF12300017GEY Yes
0 10 QSFP 40GBASE-CR4-1M
APF12300017GEY Yes
Related
Commands
• show interfaces — displays the interface configuration.
• show interfaces transceiver — displays the physical status and operational status
of an installed transceiver. The output also displays the transceiver’s serial
number.
show memory
View current memory usage on the switch.
S6000
Syntax
show memory [stack-unit id]
Parameters
stack-unit id (OPTIONAL) Enter the keyword stack-unit then the stack
unit ID of the S-Series stack member to display memory
information on the designated stack member. The unit ID
range from 0 to 11.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced this version of the command for the S-Series.
Control and Monitoring
121
To Next Page
Loading...
