Dell S6000 - Advertise Med Location-Identification

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
advertise med location-identification
To advertise a location identifier, configure the system.
S6000
Syntax
advertise med location-identification {coordinate-based value |
civic-based value | ecs-elin value}
To return to the default, use the no advertise med location-
identification {coordinate-based value | civic-based value |
ecs-elin
value} command.
Parameters
coordinate-
based value
Enter the keywords coordinate-based then the
coordinated based location in hexadecimal value of 16 bytes.
civic-based
value
Enter the keywords civic-based then the civic based
location in hexadecimal format. The range is from 6 to 255
bytes.
ecs-elin value Enter the keywords ecs-elin then the Emergency Call
Service (ecs) Emergency Location Identification Number
(elin) numeric location string. The range is from 10 to 25
characters.
Defaults unconfigured.
Command
Modes
CONFIGURATION (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Link Layer Discovery Protocol (LLDP)
911