Dell S6000 - Radius-Server Group

radius-server group
Creates or deletes a group of radius servers.
Syntax
radius-server group group-name
Parameters
group-name Enter the group name that denotes the group of RADIUS
servers.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Example
FTOS(conf)#radius-server group group1
FTOS(conf-radius-group)#radius-server host 1.1.1.1 key secret
FTOS(conf-radius-group)#radius-server host 2.2.2.2 key secret
FTOS(conf-radius-group)#radius-server vrf vrf1 source-
interface tengigabitethernet 0/36
FTOS(conf-radius-group)#show config
!
radius-server group group1
radius-server vrf vrf1 source-interface TenGigabitEthernet
0/36
radius-server host 1.1.1.1 key 7 9a2f3ec0c65c6f41
radius-server host 2.2.2.2 key 7 9a2f3ec0c65c6f41
FTOS(conf-radius-group)#
Related
Commands
login authentication — sets the database to be checked when a user logs in.
radius-server key — sets an authentication key for RADIUS communications.
radius-server retransmit — sets the number of times the RADIUS server attempts to
send information.
radius-server timeout — sets the time interval before the RADIUS server times out.
1252
Security