line rate traffic over the SP queue, it starves all other queues on the ports on which
this traffic is flowing.
Per-Port QoS Commands
Per-port QoS (port-based QoS) allows you to define the QoS configuration on a per-physical-port basis.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the traffic this interface receives.
S6000
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p configuration on the interface, use the no dot1p-
priority
command.
Parameters
priority-value Enter a value from 0 to 7.
dot1p Queue Number
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
1110
Quality of Service (QoS)
To Next Page
Loading...
