Dell S6000 - Arp Inspection-Trust

Defaults Disabled
Command
Modes
INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the E-Series.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
Related
Commands
arp inspection-trust — specifies a port as trusted so that ARP frames are not
validated against the binding table.
arp inspection-trust
Specify a port as trusted so that ARP frames are not validated against the binding table.
S6000
Syntax
arp inspection-trust
Defaults Disabled
Command
Modes
• INTERFACE
• INTERFACE PORT-CHANNEL
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the E-Series.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
538
Dynamic Host Configuration Protocol (DHCP)