Dell S6000 - Show Protocol-Tunnel

Related
Commands
show protocol-tunnel — displays tunneling information for all VLANs.
show running-config — displays the current configuration.
show protocol-tunnel
Display protocol tunnel information for all or a specified VLAN-Stack VLAN.
S6000
Syntax
show protocol-tunnel [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to
display information for the one VLAN. The range is from 1 to
4094.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series, E-Series and E-Series ExaScale.
Version 7.4.1.0 Introduced
Example
Dell#show protocol-tunnel
System Rate-Limit: 75 frames/second
VLAN Protocols Interface
1000 STP,PVST Gi 5/7,Gi 5/6
1001 LLDP,GVRP Gi 5/7,Gi 5/6
1002 MMRP,MVRP Gi 5/7,Gi 5/6
1003 LACP,DOT1X Gi 5/7,Gi 5/6
1004 OAM,PAUSE Gi 5/7,Gi 5/6
1005 E-LMI Gi 5/7,Gi 5/6
Example
(Specific VLAN)
Dell#show protocol-tunnel vlan 2
System Rate-Limit: 1000 Frames/second
Interface Vlan Protocol(s)
1318
Service Provider Bridging