Dell S6000 - Show Config

show config
View the current configuration for the mode. Only non-default values are displayed.
S6000
Syntax
show config
Command
Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-rstp)#show config
!
protocol spanning-tree rstp
no disable
bridge-priority 16384
show spanning-tree rstp
Display the RSTP configuration.
S6000
Syntax
show spanning-tree rstp [brief] [guard]
Parameters
brief (OPTIONAL) Enter the keyword brief to view a synopsis of
the RSTP configuration information.
guard (OPTIONAL) Enter the keyword guard to display the type of
guard enabled on an RSTP interface and the current port
state.
Rapid Spanning Tree Protocol (RSTP)
1213