Dell S6000 - Page 698

LineSpeed 2000 Mbit
Members in this channel: Gi 0/5 Gi 0/18
ARP type: ARPA, ARP timeout 04:00:00
Last clearing of "show interfaces" counters 00:00:00
Queueing strategy: fifo
44507301 packets input, 3563070343 bytes
Input 44506754 IP Packets, 0 Vlans 0 MPLS
41 64-byte pkts, 44502871 over 64-byte pkts, 249 over 127-
byte pkts
407 over 255-byte pkts, 3127 over 511-byte pkts, 606 over
1023-byte pkts
Received 0 input symbol errors, 0 runts, 0 giants, 0
throttles
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
1218120 packets output, 100745130 bytes, 0 underruns
Output 5428 Multicasts, 4 Broadcasts, 1212688 Unicasts
1216142 IP Packets, 0 Vlans, 0 MPLS
0 throttles, 0 discarded
Rate info (interval 299 sec):
Input 01.50Mbits/sec, 2433 packets/sec
Output 00.02Mbits/sec,4 packets/sec
Time since last interface status change: 00:22:34
Dell#
User
Information
The following describes the show interfaces port-channel brief
command shown in the following example.
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
• L3 — for Layer 3
• L2 — for Layer 2
Status Displays the status of the port channel.
• down — if the port channel is disabled (shutdown)
• up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in
hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
• In Layer 2 port channels, an * (asterisk) indicates which
interface is the primary port of the port channel. The
primary port sends out interface PDU.
• In Layer 3 port channels, the primary port is not
indicated.
Example
Dell#sh int por 1 br
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Gi 3/0 (Up) *
698
Interfaces