• The neighbor does not inherit the global BFD disable values configured with the
bfd neighbor command or configured for the peer group to which the
neighbor belongs.
• The neighbor only inherits the global timer values configured with the bfd
neighbor
command: interval, min_rx, and multiplier.
When you remove the Disabled state of a BFD for a BGP session with a specified
neighbor by entering the no neighbor bfd disable command, the BGP link
with the neighbor returns to normal operation and uses the BFD session
parameters globally configured with the
bfd neighbor command or configured
for the peer group to which the neighbor belongs.
Related
Commands
neighbor bfd — Explicitly enables a BFD session with a BGP neighbor or a BGP peer
group.
308
Bidirectional Forwarding Detection (BFD)
To Next Page
Loading...
