EasyManua.ls Logo

Dell S6000 - Page 658

Dell S6000
1510 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Usage
Information
This command is supported on C-Series, S-Series, and E-Series (TeraScale and
ExaScale) 10/100/1000 Base-T Ethernet interfaces.
The no negotiation auto command is only available if you first manually set
the speed of a port to 10Mbits or 100Mbits.
The negotiation auto command provides a mode option for configuring an
individual port to forced-master/forced slave after you enable auto-negotiation.
NOTE: The mode option is not available on non-10/100/1000 Base-T Ethernet
line cards.
If you do not use the mode option, the default setting is slave. If you do not
configure forced-master or forced-slave on a port, the port negotiates to either a
master or a slave state. Port status is one of the following:
Forced-master
Force-slave
Master
Slave
Auto-neg Error — typically indicates that both ends of the node are configured
with forced-master or forced-slave.
CAUTION: Ensure that one end of your node is configured as forced-master
and one is configured as forced-slave. If both are configured the same (that
is, forced-master or forced-slave), the show interfaces command flaps
between an auto-neg-error and forced-master/slave states.
You can display master/slave settings with the show interfaces command.
Example
(Master/Slave)
Dell(conf)# int gi 0/0
Dell(conf-if)#neg auto
Dell(conf-if-autoneg)# ?
end Exit from configuration mode
exit Exit from autoneg configuration mode
mode Specify autoneg mode
no Negate a command or set its defaults
show Show autoneg configuration information
Dell(conf-if-autoneg)#mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
Dell(conf-if-autoneg)#
Example
(Configured)
Dell#show interfaces configured
GigabitEthernet 13/18 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:05:f7:fc
Current address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 00:12:42
Queueing strategy: fifo
658
Interfaces

Table of Contents

Related product manuals