Dell S6000 - Page 763

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ip route all command in the following
example.
Field Description
(undefined) Identifies the type of route:
• C = connected
• S = static
• R = RIP
• B = BGP
• IN = internal BGP
• EX = external BGP
• LO = Locally Originated
• O = OSPF
• IA = OSPF inter area
• N1 = OSPF NSSA external type 1
• N2 = OSPF NSSA external type 2
• E1 = OSPF external type 1
• E2 = OSPF external type 2
• i = IS-IS
• L1 = IS-IS level-1
• L2 = IS-IS level-2
• IA = IS-IS inter-area
• * = candidate default
• > = non-active route
• + = summary routes
Destination Identifies the route’s destination IP address
Gateway Identifies whether the route is directly connected and on
which interface the route is configured.
IPv4 Routing
763