Dell S6000 - Page 85

Command
Modes
• CONFIGURATION
• INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
Usage
Information
The following commands are not supported by the do command:
• enable
• disable
• exit
• config
Example
Dell(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
Dell(conf-if-te-5/0)#
Dell(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
Dell(conf-if-te-5/0)#
Dell(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
Dell(conf-if-te-5/0)#
Control and Monitoring
85