Dell S6000 - Page 873

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show mac-address-table command shown in the
following example.
Column Heading Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually configured
(Static), learned dynamically (Dynamic), or associated with a
specific port (Sticky).
Interface Displays the interface type and slot/port information. The
following abbreviations describe the interface types:
• gi — Gigabit Ethernet then a slot/port.
• po — Port Channel then a number. The range is from 1
to 255 for TeraScale.
• so —SONET then a slot/port.
• te — 10 Gigabit Ethernet then a slot/port.
State Lists if the MAC address is in use (Active) or not in use
(Inactive).
Example
Dell(conf)#do show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId Mac
Address Type Interface State
2 00:00:00:00:00:01 Dynamic (N) Po
128 Active
2 00:00:00:00:00:02 Dynamic (N) Po
10 Active
2 00:00:00:00:00:03 Dynamic Po
100 Active
2 00:00:00:00:00:04 Dynamic Po
10 Active
Usage
Information
The following describes the show mac-address-table command shown in the
following example.
Column Heading Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually configured
(Static), learned (Dynamic), or associated with a specific port
Layer 2
873