Periodic Maintenance
60
Chapter 3 Maintenance
When the screen shown in the image on the left is displayed, click [OK].
The spindle unit will move, which will open the collet.
When the screen shown in the image on the left is dis‑
played, click [OK].
Retighten the collet.
Fit the wrench onto the collet.
Insert the detection pin all the way into the collet.
If the detection pin cannot be inserted, repeat the operations
in steps
to
.
CAUTION
Use the included wrench and keep the detection pin
inserted.
If the detection pin is not inserted, the collet may be
deformed, resulting in lower milling accuracy.
To Next Page
Loading...