Digi CM 8 User Manual

Configure ports Remote ports
Digi CM User Guide 55
Click Serial ports > Connection > Port number.
Remote ports are sorted below the physical serial ports as V1...
Telnet
Telnet to the IP and the port number (the specific port number is defined on the ’Host mode
configuration’ page.
telnet 143.191.3.9 7051
SSH to the port number
SSH to the IP and the port number (the specific port number is defined on the ’Host mode
configuration’ page).
SSH to the port name
SSH to the IP and the port number (the specific port number is defined on the ’Host mode
configuration’ page).
Ssh user-name:’t=port-title’@ip-Address
Ssh sunadmin:’t=Switch3level’:@MainDigi
You can access a remote port just like any local port:
- directly using the portnumber
The parameters of the remote port are equivalent to regular serial ports. Enter any additional
parameters for the remote and click Save & apply or Apply all changes.

Digi CM 8 Specifications

General

Brand	Digi
Model	CM 8
Category	Network Hardware
Language	English