Digi CM 8 User Manual

Custom and default menus Default menu
Digi CM User Guide 87
▪ TCP/IP port 22 or 23 if the “Shell program” is set to “port access menu” for this specific user (see
User administration)
▪ By calling “portaccessmenu” from the command line
The PortAccess menu allows simple access to each port.
By typing the number of the port to connect to, the Digi CM unit initiates a connection to this port
using the appropriate protocol (Telnet of SSH).
You can also change your own password by using the “P” Key.
If the Digi CM unit is configured to be the master in a master-slave scenario, the “S” key will bring up
a list of all slaves. Selecting a slave will then spawn a connection to the Port Access Menu of the
slave.
When using a Digi CM 48, not all ports can be displayed on one screen. Ports 33-48 can be viewed
after hitting the <Enter> key.

Digi CM 8 Specifications

General

Brand	Digi
Model	CM 8
Category	Network Hardware
Language	English