Digi XBee SX - T2 (D2 Output Timeout); T3 (D3 Output Timeout); T4 (D4 Output Timeout); T5 (D5 Output Timeout)

AT commands I/O line passing commands
XBee®/XBee-PRO SX RF Module User Guide
100
Parameter range
0 - 0x1770 (x 100 ms)
Default
0
T2 (D2 Output Timeout)
Specifies how long pin D2 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0
T3 (D3 Output Timeout)
Specifies how long pin D3 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0
T4 (D4 Output Timeout)
Specifies how long pin D4 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0
T5 (D5 Output Timeout)
Specifies how long pin D5 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0