Digi XBee SX - SO (Sleep Options); SN (Number of Cycles between ON_SLEEP )

AT commands Sleep commands
XBee®/XBee-PRO SX RF Module User Guide
104
Parameter Description
5 Asynchronous Cyclic Sleep Pin Wake. When you assert the SLEEP_RQ pin, the device
enters a cyclic sleep mode similar to Asynchronous Cyclic Sleep. When you de-assert
the SLEEP_RQ pin, the device immediately wakes up. The device does not sleep when
you de-assert the SLEEP_RQ pin.
6 N/A
7 Sleep Support
8 Synchronized Cyclic Sleep
Default
0
SO (Sleep Options)
You can set or clear any of the available sleep option bits.
You cannot set bit 0 and bit 1 at the same time.
Parameter range
0 - 0x13E
For synchronous sleep devices, the following sleep bit field options are defined:
Bit Option
0 Preferred sleep coordinator; setting this bit causes a sleep compatible device to always act as
sleep coordinator
1 Non-sleep coordinator; setting this bit causes a device to never act as a sleep coordinator
2 Enable API sleep status messages
3 Disable early wake-up for missed syncs
4 Enable node type equality (disables seniority based on device type)
5 Disable coordinator rapid sync deployment mode
For asynchronous sleep devices, the following sleep bit field options are defined:
Bit Option
8
Always wake for ST time
Default
0x2 (non-sleep coordinator)
SN (Number of Cycles Between ON_SLEEP )
Set or read the number of sleep periods value. This command controls the number of sleep periods
that must elapse between assertions of the ON_SLEEP line during the wake time of Asynchronous