Regulatory information ACMA (Australia)
XBee®/XBee-PRO SX RF Module User Guide
195
choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne
dépasse pas l'intensité nécessaire àl'établissement d'une communication satisfaisante.
ACMA (Australia)
Power requirements
Regulations in Australia stipulate a maximum of 30 dBm EIRP (Effective Isotropic Radiated Power).
The EIRP equals the sum (in dBm) of power output, antenna gain and cable loss and cannot not
exceed 30 dBm.
The EIRP formula for Australia is:
power output + antenna gain - cable loss <= 30 dBm
Note The maximum EIRP for the FCC (United States) and IC (Canada) is 36 dBm.
These modules comply with requirements to be used in end products in Australia. All products with
EMC and radio communications must have a registered RCM mark. Registration to use the compliance
mark will only be accepted from Australian manufacturers or importers, or their agent, in Australia. In
order to have a RCM mark on an end product, a company must comply with a or b below:
a. have a company presence in Australia.
b. have a company/distributor/agent in Australia that will sponsor the import of the end product.
Contact Digi for questions related to locating a contact in Australia.
RSM (New Zealand)
Power requirements
No antenna with gain greater that 2.1 dBi (dipole) can be used with this radio in New Zealand.
These modules comply with requirements to be used in end products in New Zealand. All products
with EMC and radio communications must have a registered R-NZ mark. Registration to use the
compliance mark will only be accepted from manufacturers or importers, or their agent, in New
Zealand. In order to have a R-NZ mark on an end product, a company must comply with a or b below:
a. have a company presence in New Zealand.
b. have a company/distributor/agent in New Zealand that will sponsor the import of the end
product.
Brazil (Anatel)
ANATEL Brazil for XBee-PRO SX radio products (XBP9X)
The XBee SX-PRO RF modules (models noted below) comply with Brazil ANATEL standards in
Resolution No. 506. The following information is required in the user manual for the product
containing the radio and on the product containing the radio (in Portuguese): Digi Model: XBP9X-
DMUS-011 e XBP9X-DMRS-011
To Next Page
Loading...
Need help?
General
