Digi XBee SX User Manual

AT commands Addressing commands
XBee®/XBee-PRO SX RF Module User Guide
75
Parameter range
0 - 0xFFFFFFFF
Default
0
DL command
Set or display the upper 32 bits of the 64-bit destination address. When you combine DH with DL, it
defines the destination address that the device uses for transmissions in Transparent mode.
The destination address is also used for I/O sampling in both Transparent and API modes.
0x000000000000FFFF is the broadcast address.
Parameter range
0 - 0xFFFFFFFF
Default
0xFFFF
TO (Transmit Options)
The bitfield that configures the transmit options for Transparent mode.
The device's transmit options. The device uses these options for all transparent transmissions. API
transmissions can override this using the TxOptions field in the API frame.
DigiMesh is not supported if BR is set to 0, transmitted packets will be sent as point-to-
point/multipoint in this case.
Parameter range
0 - 0xFF
Parameter Description
0x40 Point to point/multipoint
0x80 Repeater/Directed broadcast
0xC0
DigiMesh
Point to point/multipoint (if BR = 0)
Parameter Description
0x40 Point to point/multipoint
0x80 Repeater/Directed broadcast
0xC0
DigiMesh
Point to point/multipoint (if BR = 0)
n Bits 6 and 7 cannot be set to DigiMesh on the 10k build.
n Bits 1, 2, and 3 cannot be set on the 10k build.

Digi XBee SX Specifications

General

Brand	Digi
Model	XBee SX
Category	Control Unit
Language	English