Modes Modes of operation
XBee®/XBee-PRO SX RF Module User Guide
36
Apply command changes
Any changes you make to the configuration command registers using AT commands do not take effect
until you apply the changes. For example, if you send the BD command to change the baud rate, the
actual baud rate does not change until you apply the changes. To apply changes:
1. Send the AC (Apply Changes) command.
or:
2. Exit Command mode.
Exit Command mode
1. Send the CN (Exit Command Mode) command followed by a carriage return.
or:
2. If the device does not receive any valid AT commands within the time specified by CT
(Command Mode Timeout), it returns to Transparent or API mode. The default Command Mode
Timeout is 10 seconds.
For an example of programming the device using AT Commands and descriptions of each configurable
parameter, see AT commands.
To Next Page
Loading...
Need help?
General
