MTG2000 Trunk Gateway User Manual V| Dinstar
105
4.16.2 Tracert Test
Tracert Test is used to determine a route from one IP address to another.
Instruction for using Traceroute:
1) Enter the IP address or domain name of a destination device in the input box of
Destination, and then click Start.
2) View the route information from the returned message.
4.16.3 Signaling Call Test
On the Signaling Call Test interface, you can test whether the signaling of a call is
successfully connected. You need to select the source type, trunk type and IP trunk No. of
the call, and enter the calling number and called number. If the signaling of a call fails, you
can find out where errors have occurred through the messages returned in the Signaling
Trace box.
Signaling Call test is used to help locate the reason for a failed call. It is used to test the
signaling of a PSTN->IP or PSTN->IP call and check whether the connection is normal
or not.
To Next Page
Loading...
