Dinstar MTG2000 - Page 118

MTG2000 Trunk Gateway User Manual V| Dinstar
112
Configuration
Enable
server and send call bills.
Server IP
Address
Configure the IP address of the authentication
server.
KeepAlive Port
Configure the KeepAlive Port of the
authentication server.
Authentication
Port
Configure the Authentication Port of the
authentication server.
CDR Port
Configure the CDR Port of the authentication
server.
Custom
Domain
Configure the Custom Domain of the
authentication server.
Send CDR
When enabled, the device will automatically
send CDR to authentication server .
Record
Configuration
Recording
Enable
After enabling, the device sends the media
stream to the recording server to generate a
recording file.
Server IP
Address
Configure the IP address of the recording server.
Rcd Port
Configure the port of the recording server, which
usually is 2999.
Max Path
Maximum number of concurrent recordings.
Rcd Period
Select
Configure the time interval for recording.
Rcd Mode
Configure recording mode.
Rcd Start when
Configure the recording start time, including
connect/alert; if recording starts from connect,
the recording file will only contain the call
conversation after the call is taken, if recording
starts from alert, the recording file will contain
the ringback tone before the call is taken.
Rcd Send by
Configure the interface for sending recordings.
If Type
Type of interface, including media/management.
NAT
Disable/enable NAT; when enabled, the RTP
stream is forwarded to the configured server IP;
when disabled, the RTP stream is forwarded to
the address carried by the recording server start
ack message
recognition
configuration
Enable voice
recognition.
After enabling, the device sends the media
stream to the recognition server for voice
recognition.
Server IP
Configure the IP address of the recognition