Dinstar MTG2000 - Page 124

MTG2000 Trunk Gateway User Manual V| Dinstar
118
Parameter
Explanation
RADIUS Enable
Select RADIUS service：Disable/ Acct/ Auth/ Acct&Auth.
Radius Port
The port for connection and communication between the device
and the radius server (the default is 1813).
Max Retry
The number of retry when the device does not receive a reply
after sending a radius request.
Timeout (1~10
seconds)
The time interval between no reply after the device sends a
radius request and retransmission of the radius request.
Connect Fail Count
Only used in Acct mode, and the configured count of connect
fail does not receive a response, and the device automatically
sets the radius server to the dead state.
Server Recovery
Time (1~30 min)
After setting the recovery time, the radius server status changes
from dead to active.
Device Behavior
Upon RADIUS
Timeout
Local verification/login refused; local verification–radius server
authentication timeout, verify whether the user name and
password are consistent with the registered, if they are, the
access to the device is successful, if not, the user
name/password error will be prompted. Login is refused–Radius
server authentication timeout directly denies access, prompting
user name/password error.
Primary Server IP
Primary radius server address.
Primary Server
Auth Port
Primary radius server authentication port.
Primary Server
Acct Port
Primary radius server Acct port.
Primary Server
Key
Master radius server key.
Second Server IP
Second radius server address.
Second Server
Auth Port
Second radius server authentication port.
Second Server Acct
Port
Second radius server Acct port.
Second Server Key
Second radius server key.