Dinstar MTG2000 - Page 129

MTG2000 Trunk Gateway User Manual V| Dinstar
123
Tcpdump
Select the tcpdump (linux program) to be
loaded, click upload, and restart the device after
the upload is successful.
Certificate
Select the CA certificate file to be loaded, click
Upload, and restart the device after the upload
is successful.
Firmware Upgrade
Boot
Select the
mtgboot.ldf
file to be loaded. After
the upload is successful, the telnet device enters
^config, executes uboot update, and restarts the
device after the prompt “update uboot success”.
Kernel
Select the mtgkernel.ldf file to be loaded. After
the upload is successful, the telnet device enters
^config , executes the kernel update, and
restarts the device after the prompt “update
kernel success”.
File System
Select the mtgfs.ldf file to be loaded. After the
upload is successful, the telnet device enters
^config, executes license update, netinfo
backup, save the license and network
information of the device, and then execute fs
update. After the fs is refreshed (Do not operate
the web and do not use the web to restart the
device). You can log in to the reboot device
with SSH, or reset the device in ^config mode.
FPGA
Firmware
Upload the selected mtgfpga.ldf and restart the
device to take effect after the upload is
successful.
DSP Firmware
Upload the selected mtgdsp.ldf and restart the
device to take effect after the upload is
successful.
DSP827
Firmware
Upload the selected dsp827app.ldf and restart
the device to take effect after the upload is
successful.
Authorization
Upload the selected mtgauth.ldf and restart the
device to take effect after the upload is
successful.
Module
Upload the selected audio file and restart the
device to take effect after the upload is
successful.
Cards Update
User Board ipk
Upload the selected user board program and
restart the device to take effect after the upload
is successful.
User Board
Upload the selected user board program and