Dinstar MTG2000 - Page 36

MTG2000 Trunk Gateway User Manual V| Dinstar
30
Belong to
Parameter
Explanation
Service
Ethernet
Interface
(GE1)
IP Address
The IP address of GE1, default value is
192.168.1.111
Subnet Mask
Subnet mask of GE1
Default Gateway
The IP address of network gateway
Work Mode
Include Auto Negotiation, 1000M/Full-Duplex,
100M/Full-Duplex, 100M/Half-Duplex.
Full-Duplex: Communication in both directions
simultaneously.
Half-Duplex: Communication only in one
direction.
Ethernet Port
Bond
When enabled, both GE0 and GE1 use the IP
address of GE1 to communicate. When the GE1
network port fails, the service of GE1 is not
affected and the IP address of GE1 is still
available.
Management
Ethernet
Interface
(GE0)
IP Address
The IP address of GE0, default value is
192.168.11.1
Subnet Mask
Subnet mask of GE0
Default Gateway
The IP address of network gateway
Work Mode
Same with Work Mode of GE1
DNS Server
Master DNS
Server
The IP address of the primary DNS server
Secondary DNS
Sever
The IP address of the secondary DNS server. It is
optional to fill in.
Default
Gateway
Interface
Configuration of the device's default gateway, user
can choose GE1/GE0.
System
Parameter
Hostname
Set the name of the device.
Note：
The IP address of GE1 and that of GE0 cannot be at the same network
segment.