Dinstar MTG2000 - Page 43

MTG2000 Trunk Gateway User Manual V| Dinstar
37
Parameter
Explanation
Trunk No.
Trunk No. starts from 0 to 19, it means you can establish 20 PRI
trunks at most.
The trunk No. is decided by the No. of the E1/T1 port linked to
the trunk. But if D-channel is not enabled for a trunk, the No. of
the trunk must be the same with a trunk under which D-channel
has been enabled.
Trunk Name
The trunk name is used to distinguish the trunk from other
trunks.
Channel ID
The ID of the channel selected for the PRI trunk. The channel
ID is used for the switch to identify a PRI trunk in case that the
Trunk No. of two trunks are the same.
D-Channel
(Delta Channel)
The channel used to carry control information and signaling
information
E1/T1 Port No.
The No. of E1/T1 port linked to the PRI trunk
Protocol
Support two protocols: ISDN and QSIG. Default value is ISDN.
Switch Side
The EI/T1 port of the PRI trunk is taken as User Side or
Network Side.
Alerting
Indication
Include Alerting and Progress
Alerting: Play ring-back tone when receiving alerting signal
Progress: Play ring-back tone when receiving progress signal