MTG2000 Trunk Gateway User Manual V| Dinstar
51
Options: typical and custom. All parameters can be configured
in custom mode, and only part of the parameters of group I,
group A, and group B can be configured in typical mode
Up to 100 R2 parameters can be configured
01 means other, 11 means china
In the signaling interaction, before sending the calling number,
after receiving the request category, and after sending the
calling, switching to group II will send the calling user
category
Call with charge/Call without charge/Special tone, switch to
group B after number interaction and then send, can be
configured in group B.
When enabled, the called party picks up the phone and
respond answer and then clear ack and then answers to
continue. When disabled, respond answer, and then clear after
the called party picks up the phone.
The default is 30,000 ms. A timeout timer when no response is
received for an inter-register signaling sent during an inter-
register signaling interaction.
The default is 5,000 ms. A timeout timer when no response is
received for sending a request for the next bit of inter-register
signaling and not received number during an inter-register
signaling interaction.
The default is 3000 ms. After the control device sends an
inter-register signaling, no mutual control signal is received
from the other side, and the current inter-register is stopped
after the timeout, so that the PSTN side detects the signal until
the signal ends.
The default is 5,000 ms, the time interval between the two
answer sent.
End flag after the called number has been sent
End flag after the calling number has been sent
When an invite message without a caller's number is received,
the callee will no longer request a caller's number, and the
To Next Page
Loading...
