Dinstar MTG2000 - Page 69

MTG2000 Trunk Gateway User Manual V| Dinstar
63
Parameter
Explanation
PSTN Profile ID
The ID of the PSTN profile
Description
The description of the PSTN profile
Codec Group ID
The ID of the Codec group (the Codec group needs to be
created at the Codec Group interface first.)
RFC2833 Payload
Default value is 101.
DTMF Tx Priority 1st
There are three ways to send DTMF: RFC2833, SIP INFOR
and Inband. You can set their priority. Priority 1
st
represents
the top priority.
DTMF Tx Priority
2nd
There are three ways to send DTMF: RFC2833, SIP INFOR
and Inband. You can set their priority. Priority 2
st
represents
the second priority.
DTMF Tx Priority 3rd
There are three ways to send DTMF: RFC2833, SIP INFOR
and Inband. You can set their priority. Priority 2
st
represents
the third priority.
Nego Priority
As the called party (IP-PSTN), for RFC2833 payload type
identification, DTMF and codec negotiation, the remote
side’s configuration is the caller’s configuration, the local
side is TG’s configuration.
Overlap Receiving
Default value is ‘Disable’;
If overlap receiving is enabled, the set ‘Dial Plan’ and ‘Dial
Timeout’ will work.
Remove CLI
CLI: Calling Line Identification
Whether to remove CLI
Play busy tone to
PSTN
If ‘Yes’ is selected, when the called phone is offhook,
MTG2000 will play busy tone to the PSTN side.
Busy Tone Mode
When enabled, TG plays a busy tone instead of hanging up
the phone directly.
Srtp Param ID
Configure the SRTP rule to be used, which uses 0 by
default.