Dinstar MTG2000 - Page 79

MTG2000 Trunk Gateway User Manual V| Dinstar
73
Configuration procedures For Access M Configuration procedures for Access mode are as
follows:
1) Click the Add button to add a SIP trunk.
2) Configure parameters on the following interface according to related explanations.
As it is Access mode, you should select Yes for the Register to Remote parameter,
and enter the IP address of a softswitch.
No Prack for Incoming
Call
When disabled, the device carries require when it sends 18x.
User to
User(callee|caller)
When enabled, the forwarded invite message carries the User
to User header with the value "callee |caller".
Request Add Port
When enabled, the request line in the sent SIP message
carries the SIP trunk configuration's peer port.
OPTION Only Detects
200OK
When enabled, the link between the device and SIP trunk is
determined to be normal only when the device sends an
option message and the peer replies with 200 ok. When
disabled, the link can be judged as normal for a reply to the
option message sent by the device.
Heartbeat Bound
PSTN Group
When enabled, the device replies to the heartbeat option
message on the remote side only when one or all E1 ports of
the bound PSTN group are green.