EasyManuals Logo

Distech Controls ECLYPSE APEX User Manual

Distech Controls ECLYPSE APEX
171 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
74 ECLYPSE APEX
8. In Server Https Port, verify that the port number matches the HTTPS port number of the SSO
server in System > Web Server (e.g., 443).
9. In Access Token, you must enter the access token from the SSO Server. Copy the access to-
ken from the Server Settings (see above procedure Setting up the SSO Server) and paste in this
field.
10. In Recovery Password, enter a recovery password that you will use in a case where the server is
no longer available.
11. In Confirm Recovery Password, enter the password again.
12. Click Apply to apply and save the configuration.
13. When setting up a new SSO connection, a message is displayed to notify you that a new certificate
has been detected. To validate the authenticity of the server, click Continue.
Figure65: SSO New Certificate Detected
14. A new page is displayed confirming that the server settings are being applied. After approximately
1 minute, you can refresh your browser manually using the F5 key or close and reopen your
browser.
To switch from the SSO Mode to Radius or Local Mode, you will be asked to log in to the remote or local server.
These credentials are the ones associated to the server you wish to switch to.
ECLYPSE Web Interface

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Distech Controls ECLYPSE APEX and is the answer not in the manual?

Distech Controls ECLYPSE APEX Specifications

General IconGeneral
BrandDistech Controls
ModelECLYPSE APEX
CategoryControl Systems
LanguageEnglish

Related product manuals