©2014 DJI. All Rights Reserved.
Figure 16 Figure 17
(1) Remove Gimbal Clamp before powering on flight battery.
(2) Gimbal motor error may occur in these situations: (1) Gimbal is placed on uneven ground. (2)
Gimbal has received an excessive external force, e.g. a collision.
Please take off from flat, open ground and protect the gimbal after powering up.
Flying in heavy fog or cloud may make the gimbal wet, leading to a temporary failure. The
gimbal will recover when it dries out.
3.5 Camera
The Phantom 2 Vision+ camera powers up when the flight battery has been installed and switched on. Photos and
videos can be shot by pressing either the onboard button or the DJI VISION App. For aerial photography it
supports burst shots, continuous capture and timed capture, and exports to both Adobe DNG Raw and JPEG. For
aerial video, it shoots in full HD at (1080p30/1080i60) and can even shoot 720p60 for internet ready slow motion.
Lens cap removal
Remove lens cap before use and replace it when shooting is complete to protect the camera lens.
Figure 18
To Next Page
Loading...
Need help?
General
