To Next Page

To Previous Page

the Phantom 2 Vision+ again to recreate its Wi-Fi network. Failure to do so will cause the DJI VISION App to fail to

connect with the camera.

6.2 Use

Charging the Range Extender

Charge the Range Extender by connecting the charging port to a power supply device such as a PC or a USB

charger using a Micro-USB cable. Make sure to charge the Range Extender completely before using it for the

first time. This takes 3~4 hours depending on USB power output.

Make sure the Range Extender has enough power before each use.

Powering on the Range Extender

1. Flick the power switch to the ON position.

2. Wait for approximately 30 seconds. The Wi-Fi signal indicator will blink green indicating the Range

Extender is communicating properly.

3. Keep the Range Extender facing the aircraft during flight for the best communication link.

Power off the Range Extender after every flight to avoid discharging the battery.

Checking the Battery Level

The battery level of the Range Extender can be checked in the camera page of the DJI VISION App as shown

below. When the battery level drops to 20% or lower, the battery level icon will go red as a charging reminder.

Figure 31 Figure 32

6.3 Renaming the Range Extender SSID

Make your Range Extender SSID easier to remember by changing its name..

Questions and Answers:

Need help?

Do you have a question about the dji PHANTOM 2 VISION+ and is the answer not in the manual?

dji PHANTOM 2 VISION+ Specifications

General