©2014 DJI. All Rights Reserved.
3 Flight Test
3.1 Take off/Landing Procedures
1. Place the Phantom 2 Vision+ on open flat ground with battery indicators facing towards you.
2. Power on the Remote Controller and Range Extender, then the Smart Flight Battery.
3. Launch the DJI VISION App and start bind it with your smartphone then enter the camera preview page.
4. Wait until the Rear LED Flight Indicator blinks green. This means it has initialized and is Ready to Fly. If it
flashes yellow, it is in Ready to Fly (non-GPS) mode and will require more careful flight. Execute the CSC
command to start motors.
5. Push the throttle up slowly to take off. Refer to Remote Controller Operation (Page 25) for more details.
6. Shoot photos and videos using the DJI VISION App. Refer to DJI VISION App Usage (Page 48) for more
details.
7. To land, hover over a level surface and gently pull down on the throttle gently to descend.
8. After landing, execute the CSC command or hold the throttle at its lowest position for 3 seconds or more
until the motors stop.
9. Turn off the smart battery, Range Extender and Remote Controller.
(1) When the Rear LED Flight Indicator blinks yellow rapidly during flight, the aircraft has entered
Failsafe mode. Refer to Failsafe Function (Page 41) for details.
(2) A low battery level warning is indicated by the Rear LED Flight Indicator blinking red slowly or
rapidly during flight. Refer to the Low Battery Level Warning Function (Page) for details.
(3) View tutorials about flight for more flight information: www.dji.com/phantom2visionplus/training.
3.2 Video Suggestions and Tips
1. Work through the check list before each flight.
2. Set the gimbal working mode to Stabilized.
3. Aim to shoot when flying in Ready to Fly only.
4. Always fly in good weather, such as sunny or windless days.
5. Change camera settings to suit you. These include FOV, photo format and exposure compensation.
6. Take flight tests to establish flight routes and scenes.
7. Push the sticks gently to make aircraft movements stable and smooth.