Dodge Stealth 1994 - Ignition Switch Inspection

i
CHASSIS ELECTRICAL - Ignition Switch 8-269
Front of vehicles
19FO1'2:
4. REMOVAL OF COLUMN COVER LOWER / 5. COLUMN
COVER UPPER
After the screws have been removed, remove the covers,
while making sure not to break the grippers.
9. REMOVAL OF STEERING LOCK CYLINDER
(1) Insert the ignition key into the steering lock cylinder and
place the key in the ACC position.
(2)
Press the lock pin down with a Phillips head screwdriver
(small-size one) to remove the steering lock cylinder.
INSPECTION
IGNITION SWITCH INSPECTION
(1) Remove the knee protector, the column cover lower and
the column cover upper. (Refer to GROUP 23A - Instru-
ment Panel.)
(2) Disconnect the wiring connector from the ignition switch
and key reminder switch, and connect an ohmmeter to the
switch side connector.
(3) Operate the switch, and check the continuity between the
terminals.
NOTE
O-O indicates that there is continuity between the terminals.