CHASSIS ELECTRICAL
-
Radio and Tape Player
8-405
Tooth side of rack cable
compartment
Tooth side of rack cable
CD
AUTO
CHANGER
/
REMOVAL AND INSTALLATION
i
/
id
,
(3) Extend th
e antenna pole up to its farthest point.
NOTE
If the motor end of the rack cable is bent, straighten it.
(4) Force the rack cable into the motor assembly with the tooth
side of the rack cable toward the luggage compartment.
(5) Turn the tooth side of the rack cable toward the rear of the
vehicle
(90’
clockwise) to bring the rack cable into mesh
with the motor gear.
(6) Lightly pull the rack cable. If it comes out without
resistance, it means that the rack cable is not in mesh with
the motor gear. Recheck that the rack cable end is not bent
before repeating the above-mentioned steps (2) and (3).
(7) With the antenna pole upright and the radio switch at OFF,
take up the rack cable. As the rack cable is taken up, insert
the antenna pole toward the motor antenna.
(8) After the ring nut has been tightened, set the radio switch
to ON and OFF to check the operation of the antenna pole.
16F0475
-
Removal steps
I.
CD changer cover
Luggage compartment floor carpet,
high
floor center board.
2. CD auto changer
3. CD changer bracket (front)
4. CD changer bracket (rear)
To Next Page
Loading...
