8-356
CHASSIS ELECTRICAL
-
Wiper and Washer Svstem
Connector
B
-~_
WFOJZOO
____.
18N0027
18N007
18N004!
Front
deck
garnish
Inspection of Wiper Relay (Built-in Column Switch)
(1) Check to ensure that there is continuity between terminals
@
and
@
and between the terminals
@
and
@,
and that
there is no continuity between terminals
@
and
0.
(2) Connect the positive terminal of the battery to terminal
@
and the negative terminal to terminal
@
to check that the
battery voltage is available at terminal
@.
INSPECTION OF WASHER MOTOR
(1)
When the washer motor is inspected, make sure that it is
mounted on the washer tank and that the washer tank is
filled with water.
(2) Connect the battery as shown to check whether water is
pumped out.
INSPECTION OF WASHER FLUID LEVEL SENSOR
(1)
Connect a circuit tester to the connector of the level sensor
as shown.
(2) Check that when the float is moved down, the circuit is
closed and that when the float is moved up, the circuit is
opened.
SERVICE POINTS OF INSTALLATION
2. INSTALLATION OF WIPER ARM
(1)
The wiper arms, right and left, are different in shape.
Check the identification symbol.
(2) After the wiper blades have been set, install them in
such a way that the ends of the wiper blades will stop at
the specified positions (standard
yalues).
Standard value: (A) 15
‘3
(3
?f
in.)
L)
I
I
\
J’
To Next Page
Loading...
