Dodge Stealth 1994 - Rear Seat Cushion Removal and Installation; Whip Antenna. Antenna Feeder Cable

CHASSIS ELECTRICAL - Radio and Tape Player
8-403
WHIP ANTENNA . ANTENNA FEEDER CABLE m AMPLIFIER
REMOVAL AND INSTALLATION
45Nm
33ftlbs.
3.6 - 4.3
ftlbs.
lemoval steps of whip antenna
Rear side trim (LH)
(Refer to GROUP 23A-Trim.)
1. Mast antenna
2. Mounting nut
3. Mounting insulator and packing
4. Antenna base and antenna feeder connec-
tion
5. Antenna base
16FO492
Removal steps of antenna feeder
Rear side trim (LH)
Quarter trim (LH)
>
!f:;,to GROUP 23A
Rear console assembly
(Refer to GROUP 23A-Console Box.)
Radio and tape player
(Refer to P.8-400)
4. Antenna feeder cable and antenna base
connection
+* l +
6. Rear seat cushion
7. Rear seatback
8. Inner seat belt
9. Console side cover (LH)
10. Antenna feeder cable
11. Sub antenna feeder cable
Amplifier removal
12. Amplifier (under passenger’s seat)
SERVICE POINT OF REMOVAL
6. REMOVAL OF REAR SEAT CUSHION
Raise and remove the seat cushion with the lever pulled.
INSPECTION
INSPECTION OF ANTENNA MOTOR <VEHICLE WITH
MOTOR ANTENNA>
Disconnect the motor antenna control unit connector, connect
the positive terminal of the power supply to terminal @ and
connect the negative terminal to terminal @ to check that the
antenna goes up, and that when the connections are reversed,
the antenna goes down.