Dodge Stealth 1994 - Intermittent Wiper Relay

CHASSIS ELECTRICAL - Wiper and Washer System
8-359
18N007E
INTERMITTENT WIPER RELAY
(1) Remove the quarter trim. (Refer to Group 23A - Trim.)
(2) With the intermittent wiper relay connected to the wiring
harness connector, let the wiper operate intermittently and
check the voltage at terminal 0.
Condition
Standard
When wiper is stationary
ov
When wiper is in operation
Battery voltage
WASHER MOTOR
(1) When the washer motor is inspected, make sure that it is
mounted on the washer tank and that the washer tank is
filled with water.
(2) Connect the battery as shown to check whether water is
pumped out.
SERVICE POINT OF INSTALLATION
2. INSTALLATION OF WIPER ARM
After assembling the wiper blade to the wiper arm,, install
the wiper arm with its tip positioned along the ceramic part.