Liftgate
moulding.
upper
-
8. REMOVAL OF
LIFTGATE
MOULDING, UPPER
Using a special tool, pry the clip portion to remove the
upper
liftgate
moulding.
‘d
8-358
CHASSIS ELECTRICAL
-
Wiper and Washer System
SERVICE POINT OF REMOVAL
!/
18FO142
Inspection
of
operation
18N0029
Inspection
of
stop
posltion
16FO191
16FO201
INSPECTION
WIPER MOTOR
Check the wiper motor with it mounted on the vehicle and with
its harness connector disconnected.
Operation of Wiper Motor
Connect a battery to the wiper motor, as shown, to check the
operation of the wiper motor.
Wiper Motor Stop Position
(1)
Operate the wiper motor by the procedure described above
and intermediately disconnect the battery to let the wiper
m’otor
stop.
(2) Reconnect the battery as shown and check that the wiper
motor stops at the automatically-stopped position after
I
operation.
‘L)
WIPER WASHER SWITCH
(1)
Remove switch garnish B from the knee protector.
(2) Operate the switch to check for continuity between the
terminals.
NOTE
O-O denotes
that there is continuity between the terminals
To Next Page
Loading...
