Dodge Stealth 1994 - Horn Switch Removal and Installation

8-362
CHASSIS ELECTRICAL - Horn
COMPONENT LOCATION
Theft-alarm horn relay
16F018E
OPERATION
l The horn switch always receives battery voltage
via the dedicated fuse @ and the coil of the horn
relay.
0 When the horn switch is set to ON, the contacts
of the horn relay close.
Then current flows through the dedicated fuse
@to the contacts of the horn relay, the horn and
ground, causing the horn to sound.
HORN SWITCH
REMOVAL AND INSTALLATION
Removal steps
1. Air bag module (Refer to GROUP 23B -
Air Bag Module and Clock Spring.)
2. Horn switch (Steering wheel assembly)
Horn relay
TROUBLESHOOTING HINTS
One of the horn does not sound.
l Check the horn.
2. Horns do not sound.
l Check the horn switch.
l Check the dedicated fuse @.
NOTE
(I) For vehicles equipped with the theft-alarm sys-
tem, refer to P.8-412.
(2) For information concerning the horn relay and
theft-alarm horn relay, refer to P.8-363.
16FO506