- Rotating Atomizer with External Charging
Version:: 07 • As of:: 01/2020
• Apply the assembly tool flush on the paint pipe.
Fig. 86: Applying the assembly tool to the paint pipe
1 Assembly tool
2 Paint tube
• Grease the sealing lip of the needle seal lightly using special
grease.
• Push needle seal carefully on the assembly tool with the sealing lip
outwards.
Fig. 87: Applying the needle seal
1 Assembly tool
2 Paint pipe
3 Needle seal
4 Sealing lip
• Carefully put the needle seat in the correct position on the
assembly tool. Note the position of the dowel on the needle seat.
• Lightly grease the needle seat outside with special grease, at the
marked locations.
Fig. 88: Pushing up needle seat
1 Assembly tool
2 Paint pipe
3 Needle seat
4 Lightly lubricate with special grease
• Paint the threads on the paint tube with screw lock.
To Next Page