Rev 00
Dr.coffee Product Maintenance Manual 31
7.1.4.21 Rear Outlet（ml）
Means the water after mixing powder.
Range: Please refer to the drinks parameter of the interface.
7.1.4.22 Powder Output Speed（%）
Means the powder output speed, the large the value, the faster the speed.
7.1.4.23 Water Temp（℃）
Means the water temp of mixing powder. Range: Please refer to the drinks parameter of the interface.
7.1.4.24 Powder Selection
Means set the type of powder.
Precautions for powder parameter setting:
1. The sum of the water output setting in the front section and the water output setting in the rear end cannot be greater than the total water volume setting
(if the water output in the front section and the water output in the rear section add more than the total water volume, there will be no water mixed with the
powder, so the powder will not be discharged );
2. Powder gram weight setting If the powder gram weight is set a lot but the total water is insufficient, only the mixed water mixed with the powder in the
middle will be produced, and the excess gram weight will not be powdered (for example: if cocoa powder The gram weight of the material is set to 70g, and it
takes 10s to discharge, and the amount of mixed water in the middle is 100ml, and it takes 7.5s to discharge, then after 7.5s, the powder is no longer powdered,
and the actual powder is 70/10*7.5 =52.5g);
3. After removing the water from the front section and the water from the back section, the remaining water volume is the mixed water volume mixed with the
powder;
4. If the amount of mixed water mixed with the remaining powder after deducting the water from the front section and the water from the back section is less
than 20ml, the powder feeding screw is not enough to rotate a circle, and it is likely that only a little powder or no powder can be pushed out;
5. If the amount of water in the front section and the back section is greater than the total water volume, the water outflow in the back section that is more
than the total water volume will stop the water discharge and end the drink making when the total water volume is reached;
6. Changing the powder feeding speed will change the time required for powder feeding. (If it is 100% soy milk powder, if the powder feeding speed is set to 15
grams, it will take 80ml and 6 seconds. If the powder feeding speed is changed to 50% but other parameters are not changed, the actual powder output will be
only half of the previous one, that is, 7.5 grams. If you want to produce 15 grams of soy milk powder at 50% powder feeding speed, you need to change the
water volume, which requires 160ml of mixed water and 12 seconds to complete the powder);
Take powder：test the actual amount that is sufficient by default (download the gram weight of powder under the beverage setting interface to help measure
whether there is an error between the set value and the actual powder output to determine whether it is necessary to enter the powder calibration)
7.1.4.25 Hot Water（ml）
Means the value of of hot water. Unit: ml Range: Range: Please refer to the drinks parameter of the interface.
7.1.4.26 Water（ml）
Means the value of of water. Unit: ml Range: Please refer to the drinks parameter of the interface.
7.1.4.27 Milk（s）
Means the time of milk out. Unit: s. Range: Please refer to the drinks parameter of the interface.
To Next Page
Loading...