Rev 00
Dr.coffee Product Maintenance Manual 76
6.2.3 Dismantle grinding bean group
Step 1: (as shown in Figure 3) Lift up the bean grinder, and then pull out the power cord plug of the left and right bean grinder
shown in the position of the main control board (as shown in Figure 4);
Step 2: Lift up the bean grinder, remove the Hall sensor set as shown in Figure 5, and then (as shown in Figure 6) unplug the
wiring plug of the bean grinder motor. Finally, take out the entire bean grinder set and complete the removal of the bean grinder
set.
★ Precautions:
1. Please unplug the coffee machine before doing this!
2. Before disassembling the bean grinder, please empty the residual coffee beans and coffee powder in the bean grinder!
7
5
6
1
2
3
4
To Next Page
Loading...
