Dräger Infinity Acute Care System - Parameter Priority; Configuring the Parameter Priority and Display; Parameter Priority List

Operating Concept
52
Instructions for Use Infinity Acute Care System - Monitoring Applications SW VG1
Parameter Priority
The parameter priority determines what position a
parameter occupies on the screen. The number of
parameters appearing as waveforms and
parameter boxes depends also on the selected
Waveforms setting (see page 278).
In the auto-view setup page (see page 277) you
determine the display location and display status of
each parameter. In the auto-view mode, you can
also use the auto-view setup toolbar to change the
parameter priority (see page 280). In the manual
mode, you can only change the parameter priority
in the Auto-view setup page.
Configuring the Parameter Priority and
Display
The location of a parameter in the window
determines not only where a parameter appears on
the screen but also how it is displayed. Parameters
are arranged in descending order in the window
and occupy the same position on the screen. For
example, the top parameter in the parameter
selection window occupies the top spot on the main
screen. For more information, see "Configuring
Parameters for Display" on page 279.
Parameter Priority List
The priority list appears in the parameter selection
window of the Auto-view setup page (see
page 277). You can change the parameter priority
by switching the position of the parameters in the
Auto-view setup page. For more information, see
"To configure the parameter priority and display
from the auto-view setup toolbar." on page 280.
The following list shows the default parameter
priority list. Pressures without assigned labels
appear as GP1, GP2, GP3, or GP4.
1 ECG (ST)
2 SpO
2
3 RRi
4 ART
5 PA
6 CVP
7 RA
8 LA
9 LV
10 LA
11 RV
12 ICP
13 NIBP
14 T (temperature)
15 T1
16 CO
2
17 C.O. (not available in the neonatal mode)
18 GP1
19 GP2
20 GP3
21 GP4
22 SpO
2
23 etCO2
24 Vent
25 Paw