Raising the machine head
–
Remove covering c ap 1.
Lift the covering c ap at the front so that the arrest is released. Lift
the covering cap carefully.
–
Swivel the folding station 3 by 90°.
–
Swing the locking pin 4 upwards.
–
Lift the fabric sliding sheet 6 at the front and swing it to the left.
–
Lift the machine head in the area of head cover 5 and raise it
carefully.
Pawl 2 snaps in additionally.
The area underneath the machine table is accessible for cleaning.
Caution: Danger of injury !
Do not reach into the table top cutout when the machine head is
raised.
Sw inging the machine head back
–
Hold the machine head in the area of head cover 5.
–
Release pawl 2.
–
Swing the machine head back carefully.
Attention: Danger of breakage!
Hold the machine head tight until it finally rests on.
–
Insert fabric sliding sheets
–
Swivel the locking lever 4 downwards.
–
Swing the folding station 3 back and let it catch in the locking lever.
–
Put on covering cap 1 and arrest again.
9
3
2
To Next Page
Loading...
Need help?
General
