5.4 Adjusting the slant of the corner incisions
Caution: Danger of injury !
Switch off the main switch.
Adjust the corner knives only with the sewing unit switched off.
Standard checking
The incisions of the corner knives should be as close to the seam as
possible, but must not cut it.
–
Adjust the maximum sewing length at the control.
–
Sew a test seam.
It is advisable to iron a piece of Vlieseline
â
onto the workpiece
before. By this the corner incisions become better visible.
–
Check seam and cutting pattern.
–
Loosen screw 6.
–
Adjust the corner knife holder 2 correspondingly.
–
Tighten screw 6.
–
Adjust the other three knife holders according to the seam pattern.
72
6
2
To Next Page
Loading...
Need help?
General
