6.1 Aligning the laser markings
Caution: Danger of injury !
Laser light.
Do not look into the light source.
The markings 13 mark the seam beginning, the markings 14 the middle
of the pocket opening and the markings 15 the seam end.
The markings 1, 2 and 4, 5 must be aligned as to the cutting line 8
(middle of pocket opening).
The distance between the middle of the pocket opening and the
measuring line 6 must amount to 125 mm.
–
Loosen clamping nut 9 and 10 slightly.
–
Align distance and angle of the laser module to the cutting line 8 by
shifting and turning.
–
Tighten clamping nut 9 and 10.
–
Loosen clamping nut 12 slightly.
–
Align the laser line by turning the laser 11.
–
Tighten clamping nut 12 again.
After adjustment of the markings please consider the following in any
case:
–
Check the markings and their alignment as to the middle of the
pocket.
–
Observe the maximum sewing area.
–
The intensity of the marking lasers can be adjusted with screw 16.
76
16 12 11 10 9
15 14 13
To Next Page
Loading...
Need help?
General
